AST RESEARCH, INC. TECHNICAL BULLETIN # 1434 6-28-96 TITLE: Premmia GX and Adaptec PCI 2940 SUMMARY The Premmia GX system may experience a POST error when an Adaptec adapter is installed. This issue applies to all the Premmia GX systems. ISSUE When an Adaptec PCI 2940 SCSI adapter is installed in a Premmia GX, the system may display POST error 16.02 (below) during a warm boot. Board was installed but not configured in slot 15. This will occur only with Premmia GX BIOS versions 3.00 and 3.01. BACKGROUND The Adaptec PCI 2940 SCSI is automatically configured during initial installation, and may conflict with system resources. ACTION 1. Run the EISA Configuration Utility (EISACU) version 1.08 (AST Part Number 911371-039). File 11371039.EXE is downloadable from any one of AST's On-Line! services below: AST WWW Site: http://www.ast.com AST On-Line! BBS*: See IB0001.TXT CompuServe: GO: ASTFORUM Prodigy: Jump: AST Support 2. Under EISACU, configure the Adaptec PCI 2940 for any of the offered options for the I/O starting address, in the range between "0F000h-0F0FFh" and "0FF00h-0FFFFh", except for I/O address "0FC00h-0FCFFh". For additional information on the EISACU, see Software Bulletin # 0319 on AST's On-Line! services. NOTES N/A TAN N/A --------------------------------------------------------------------- The information in this data sheet is subject to change without notice. AST Research, Inc. shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. This material contains information protected by copyright. No part of this material may be reproduced in any form without prior written consent from AST Research, Inc. All rights reserved. ---------------------------------------------------------------------