AST RESEARCH, INC. TECHNICAL BULLETIN # 1378 7-19-96 TITLE: Manh P/V EISACU, NCR PCI SCSI Enabled SUMMARY After running the EISA Configuration Utility (EISACU) on the Manhattan P and V, the embedded PCI SCSI is re-enabled. This issue applies to the following systems: 501500, 501502, and 501830. ISSUE When the embedded PCI SCSI is disabled through EISACU v3.04/REL 1.04, every time EISACU is run, the embedded PCI SCSI is re-enabled. No message appears to warn the user that the embedded SCSI has been re-enabled. BACKGROUND N/A ACTION EISA Configuration Utility v3.09/R1.09 (AST part number 911371-040) resolves the problem. The NCR on-board controller will remain disabled when that option is saved. File 11371040.EXE is available from any of AST's On-Line! services including: AST WWW Site: http://www.ast.com AST On-Line! BBS*: See IB0001.TXT CompuServe: GO: ASTFORUM Prodigy: Jump: AST Support * Refer to IB0001.TXT for a list of AST's international BBS numbers. To decompress this file, create a temporary directory on your hard drive, copy the downloaded file to that directory, and run the file. For additional information on the EISACU for AST PCI/EISA-based systems, see Software Bulletin 0211 on AST's On-Line! services. NOTES N/A TAN 007122JD --------------------------------------------------------------------- The information in this data sheet is subject to change without notice. AST Research, Inc. shall not be liable for technical or editorial errors or omissions contained herein; nor for incidental or consequential damages resulting from the furnishing, performance, or use of this material. This material contains information protected by copyright. No part of this material may be reproduced in any form without prior written consent from AST Research, Inc. All rights reserved. ---------------------------------------------------------------------