HP OMNIBOOK 300, 425, AND 430 - USING DYNACOMM WITH CALLING CARDS



  ISSUE:HP OmniBook 300, 425, and 430 - using a calling card in

              DynaComm.



  SOLUTION:The following procedure describes how to use a calling

              card in DynaComm on the HP OmniBook 300, 425, and 430.

  

  USING CALLING CARDS



              Calling cards may differ in the number of digits that

              must be entered.  The steps below are intended for a

              calling card with two numeric sequences.  These steps

              can be easily modified as needed by repeating steps 5

              and 6 below and steps 1 and 2 under Using the Function

              Keys.

  

  DEFINING THE FUNCTION KEYS



              1. In DynaComm, select the Settings menu.

              

              2. Choose Function Keys.

              

              3. Ensure the Key Level is 4.

              

              4. Decide which function keys you will use for the

                 phone number and the calling card number.  For this

                 example, F1 is used for the phone number and F2 is

                 used for the calling card number.

              

              5. Select the F1 Key Name and type in a description.

              

              6. Select the F1 Key Command and type in ATDTxxxxxxx;^M

                 where xxxxxxx is the phone number.  Be sure to

                 include the semicolon to stay in command mode.

              

              7. Select the F2 Key Name and type in a description.

              

              8. Select the F2 Key Command and type in ATDTxxxxxxx^M

                 where xxxxxxx is the calling card number.  A

                 semicolon is not needed on the final sequence of

                 numbers.

              

              9. Select OK when finished.

  

  USING THE FUNCTION KEYS



              1. Select the F1 function key by either pressing [Ctrl]

                 + [Alt] + [F1] or by clicking the soft key with the

                 mouse.

              

              2. When you are ready to proceed with the calling card

                 number, select F2 by either pressing [Ctrl] + [Alt]

                 + [F2] or by clicking the soft key with the mouse.

              

              3. DynaComm will now continue to establish the

                 connection.

              

                  Copyright  Hewlett-Packard Co. 1996

       This information is subject to change without notice and

                 is provided "as is" with no warranty.

          Hewlett-Packard shall not be liable for any direct,

        indirect, special, incidental or consequential damages

             in connection with the use of this material.