Philips PCD 200
Philips PCD 200 is a typical example of branded (not
assembled from Taiwanese parts) 286 from early 1990s. It has fast 12MHz
286 CPU, RAM in 30-pin SIMM sticks and 40 or 60MB ATA hard disk. While
maintaining a small case it was possible to add 2 ISA slots using riser
board. In mainboard, there were serial and parallel ports as well as
disk drives controllers and VGA graphics chip allowing to get even
640x480 in 256 colors. These times VGA graphics was reserved to higher
class computers, not typical office machines which could work with
Hercules.
PCD 200 was sold in 1991 in Europe, mostly France but also in Poland. It
was one of more expensive desktops and optionally came with VGA monitor
and keyboard.
Manufacturer | Philips | |
Origin | Nederlands | |
Year of unit | 1992 | |
Year of introduction | 1991 | |
Class | AT | |
CPU | Intel 80286 | |
Speed | 12MHz | |
RAM | 4MB | |
ROM | PC BIOS | |
Graphics | VGA (640x480x256col) on-board | |
Sound | PC Speaker | |
System expansion bus | 16-bit ISA (2 slots on riser card) | |
Floppy/removable media drives | 1x 3.5" 1.44MB drive | |
Hard disk: |
Maxtor
7060AT (C/H/S: 1024/7/17) |
|
Peripherals in collection: |
||
Other boards:
|
None | |
Non-standard expansions: | Serial and parallel port controllers built-in mainboard | |
Operating system(s): | MS-DOS 6.22 |
The history of my unit is not known. It came in professionally sanitized state, in which the hard disk has been erased and all partitions filled up with DOS 6.22 installation files. It looks like it survived CMOS battery leak which left traces near front panel switches as the battery was external. Not much documentation can be found about it.
Contents: | Starting, usage | Configuration |
Starting
The machine boots with Phoenix BIOS and if the setup has to be started a key has to be pressed. There is no built-in diagnostics or disk formatter. After memory test, the computer boots FDD and then if it fails, hard disk. Quite typical.
Most configuration is done in BIOS Setup. There are some undocumented jumpers in the mainboard.