Fujitsu M2622/23/24HA:Switch Settings

PCA Layout    All configurations marked "*" are default settings

Terminal CNH1

PER defaults
        1-2     SHORT(*)   0
                OPEN       1
SCSI level
        3-4     SHORT      SCSI-1/CCS mode
                OPEN(*)    SCSI-2 mode
Offline self diagnostics
        5-6     SHORT      Diagnostic mode
                OPEN(*)    Normal mode
UNIT ATTENTION report mode
        7-8     SHORT(*)   Reports with CHECK CONDITION status
                OPEN       Does not report with CHECK CONDITION status
Reselection retry
        9-10    SHORT(*)   Retry count = unlimited
                OPEN       Retry count = 10

       11-12    SHORT(*)   Reserved
SCSI Bus Parity
       13-14    SHORT(*)   Executed
                OPEN       Not executed
Synchronous Data Transfer Request
       15-16    SHORT(*)   Enabled from TARG
                OPEN       Disabled from TARG
LED display requirement
       17-18    SHORT(*)   LED activated when drive seeking
                OPEN       LED activated when drive idle
Motor Start Mode
       19-20    SHORT(*)   On Power Up
                OPEN       Via START/STOP UNIT Command
SCSI Terminating Power
       21-22    SHORT(*)   Power supplied from IDD
                OPEN       Power suuplied from TRMPWR pin only

Terminal CNH2

        1-2     OPEN(*)    User must not change this setting
        3-4     OPEN(*)    User must not change this setting

Terminal CNH3

Spindle synchronisation termination
        1-2     OPEN(*)    No termination
                SHORT      Termination installed

Terminal CNH4

For spindle synchronisation cable
        Pin     Function
         1      GROUND IN
         2      SPSYNC IN
         3      GROUND OUT
         4      SPSYNC OUT

Terminal CHN7

Set SCSI ID
   (note) Always ensure that each device on the SCSI bus has been given
          a unique ID. Normally the host adapter will take or assume
          SCSI ID 7.  Check your host adapter documentation for more
          details.

        5-6      3-4     1-2      ID
        OPEN(*)  OPEN(*) OPEN(*)  0
        OPEN     OPEN    SHORT    1
        OPEN     SHORT   OPEN     2
        OPEN     SHORT   SHORT    3
        SHORT    OPEN    OPEN     4
        SHORT    OPEN    SHORT    5
        SHORT    SHORT   OPEN     6
        SHORT    SHORT   SHORT    7

Write Protection
        7-8      SHORT(*)  Disabled
                 OPEN      Enabled
        9-10     OPEN(*)   RESERVED

Connector CN5

External LED connection
         Pin     Signal
         01      LED(V)
         02      -LED

Connector CN6

External SCSI ID connector
   (note) Ensure that the device has been physically set to SCSI ID 0
          (zero) before attempting to use this connection.

         Pin     Signal
         01      GND
         02      -ID2 (bit 4)
         03      GND
         04      -ID1 (bit 2)
         05      GND
         06      -ID0 (bit 1)

to the table of contents!!