CP30540 Customer options

CP30540
Customer options

SCSI Bus Address
There are three jumpers available for configuration of SCSI ID: E1, E2, and E3. The following table defines the settings:

(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)

SCSI Bus Addresses*

E1/0E1 E2/0E2 E3/0E3 SCSI ID

OUT OUT OUT O

IN OUT OUT 1

OUT IN OUT 2

IN IN OUT 3

OUT OUT IN 4

IN OUT IN 5

OUT IN IN 6

IN IN IN 7

SCSI Bus Addresses*
E1/0E1	E2/0E2	E3/0E3	SCSI ID
OUT	OUT	OUT	O
IN	OUT	OUT	1
OUT	IN	OUT	2
IN	IN	OUT	3
OUT	OUT	IN	4
IN	OUT	IN	5
OUT	IN	IN	6
IN	IN	IN	7

*Use either but not both: E1 to E3 or 0E1 to 0E3. The 0E header is not installed on drive configurations with a LED on the PCBA.
Disable Spin: A jumper in the E4 location disables spin up on power-on. Disabling spin up on application of power can also be enabled by settting the DSPN bit in MODE SELECT page 0.

E4 Disable Spin on Power on

E5 Terminators on 0E5

E4	Disable Spin on Power on
E5	Terminators on	0E5

J4

1 +12 V

2 Ground
3 Ground

4 +5V

J4
1	+12 V
2	Ground
3	Ground
4	+5V

Mounting Holes

Side: 6-32 UNC-2B .15 Max. Insertion

Bottom: 6-32 UNC-2B .25Max. Insertion

Mounting Holes
Side: 6-32 UNC-2B .15 Max. Insertion
Bottom: 6-32 UNC-2B .25Max. Insertion