CP2124
Customer Options
The CP2124 drive is designed to operate either as a Master drive (C drive) or a Slave drive (D drive). This feature is dependent on two drive settings; the status of hardware Jumper M/S and the firmware setting of a feature bit. When (M/S) is closed, and the feature bit is set, the drive will assume the role of a Master drive. When (M/S) is open, and the feature bit reset, the drive will act as the Slave. In single drive configurations, M/S must remain in the closed position.
(The table on this page requires NETSCAPE version 1.1 or later for proper viewing.)
| CMOS Drive Parameters |
| Cylinders | 762 |
| Heads | 8 |
| Sectors | 39 |
| Precomp | 0 |
| Landing Zone | 762 |
| Mounting Holes |
| Side: 3mmx0.5mm THD4x) 4mm Max. Insertion |
| Bottom: 3mmx0.5 THD (4x) 4mm Max. Insertion |